Open now, 24/7 emergency electrician across Wisconsin(888) 633-7804
Tony Feuerhelm ElectricCall (888) 633-7804

Home / Locations / Combined Locks / Electrical Panel Upgrade

Electrical Panel Upgrade in Combined Locks, WI

Thinking about an EV charger, a heat pump, a hot tub or a kitchen remodel? In Combined Locks the first question is usually whether the panel can take it. We handle the full 100 amp to 200 amp upgrade: permit, utility coordination, new panel, new breakers and inspection.

About our electrical panel upgrades in Combined Locks

A service upgrade is more than swapping a metal box. We run a load calculation to confirm the right size, replace the panel and main breaker, and upgrade the meter socket, service cable and grounding where needed. The utility disconnects and reconnects the service, and the work is permitted and inspected. Most Combined Locks panel replacements are finished in a single day with the power off for a few hours. Every circuit is labeled clearly when we are done, which sounds minor until the day you need to find one in a hurry.

Combined Locks belongs to northeast Wisconsin's string of working towns around the Fox River, Lake Winnebago and Green Bay, with housing that ranges from early-1900s homes to new subdivisions. In Outagamie County we regularly upgrade older services, rewire two-story homes built before grounding was standard and wire new construction on the edge of town.

If you are in Combined Locks, Little Chute, Kimberly or Kaukauna and searching for electrical panel upgrade near me, you are in our service area.

Electrical Panel Upgrade services we provide in Combined Locks

Fuse box replacement

Old fuse panels converted to a modern breaker panel, a common request from insurers and buyers.

Sub panel installation

A sub panel for a garage, workshop, addition or finished basement when the main is out of spaces.

Panel upgrade cost estimates

A written, itemized quote after a site visit, so you know the electrical panel upgrade cost before deciding.

200 amp panel upgrade

The standard for today's homes, with capacity for EV charging, electric heat, air conditioning and future additions.

100 amp to 200 amp upgrade

Full service upgrade including meter socket, service entrance cable, grounding and bonding.

Breaker box replacement

Worn, rusted, overheated or recalled panels replaced with a new panel and breakers of the same size.

Signs your Combined Locks home needs a panel upgrade

  • The panel is full, with tandem breakers squeezed into every slot
  • You still have a fuse box or a 60 amp service
  • The panel is warm, rusted, buzzing or smells of burning
  • You are adding an EV charger, heat pump, hot tub or addition
  • Breakers trip when two large appliances run at once

Common questions about electrical panel upgrades in Combined Locks

How much does an electrical panel upgrade cost in Combined Locks?

The price depends on the service size, whether the meter socket and service cable need replacing, how the service reaches the house and the condition of the grounding. We look at your setup and give a fixed written quote, so the electrical panel upgrade cost is clear before any work is booked.

How long will my power be off?

Usually four to eight hours on the day of the swap. We schedule the utility disconnect and reconnect in advance to keep the outage as short as possible.

Do I need a 200 amp panel or is 100 amp enough?

A small home with gas heat, gas water heating and no EV can run well on 100 amps. Add electric vehicle charging, a heat pump, an electric range or a hot tub and 200 amps is normally the right call. A load calculation settles it.

Is a permit required for a panel replacement in Combined Locks?

Yes. Panel and service work in Wisconsin requires an electrical permit and inspection. We handle the paperwork and meet the inspector.

What to expect when you call

  1. Call (888) 633-7804

    Tell us what is happening. For emergencies we dispatch right away; for planned work we book a time that suits you.

  2. Diagnosis and fixed quote

    An electrician looks at the job, explains what is needed in plain language and gives you a price before starting.

  3. Work done to code

    We complete the work with the right materials, pull any permit required and test everything.

  4. Walkthrough and cleanup

    We show you what was done, label the panel where it applies and leave the space clean.

Call for electrical panel upgrades in Combined Locks

A local electrician is ready, day or night.

(888) 633-7804
Call (888) 633-7804